List of products by brand Beal

WARM-UP Silicone Balls are used to warm up the climber's fingers before starting on a route or boulder. Packaged in a carrying case, they come in a variety of hardnesses, each identified by a different color.

Compact aluminium swivel with ball bearings to optimise performance even when loaded.

The TRANSF'AIR FIXED pulley is a pulley designed for load deflection, hauling and coupling with a mechanical blocker. Compact and light, it is very easy to handle. Its good performance is ensured by a sheave mounted on a bronze ring. Its durability is reinforced by a stainless steel shaft and washer. And to ensure traceability, each pulley has an...

The TRANSF'AIR 2 twin pulley is a pulley designed for load deflection and hauling. Single pulley with a mobile flange, it is perfectly adapted to ropes with large diameters, the mobility of the flanges facilitating the positioning of the pulley at any point on the rope. The good performance is ensured by a sheave mounted on a bronze ring. Its durability...

The TRANSF'AIR 1 pulley is a pulley designed for load deflection and hauling. Single pulley with a mobile flange, it is perfectly adapted to ropes with large diameters, the mobility of the flanges facilitating the positioning of the pulley at any point on the rope. The good performance is ensured by a sheave mounted on a bronze ring. Its durability is...

A rope can wear very rapidly over a sharp edge. To protect it, use the PROTECTOR, an ultra-solid rope protector made of two layers of coated material.

Beal's ROPE BRUSH was created specifically for cleaning ropes and is easily adapted to different rope diameters. To use it, screw the brush onto the rope and then slide the rope while holding the brush firmly in the water. Your rope will come out looking like new!

The ORIENT EXPRESS is a unidirectional locking carabiner designed for use with belay devices. Thanks to the internal snap gate that clips onto a harness belay loop, the carabiner cannot turn over. This ensures the carabiner stays in the correct direction thus reducing the risk of the belay system being weakened through cross loading.

Symmetrical aluminium oval shaped connector for use with equipment with swivelling side plates such as pulleys, rope clamps, mobile fall arrest devices, etc.

Multifunction sling for climbing and mountaineering. With its 8.3mm diameter and its 22kN resistance, the DYNALOOP sling is an essential piece of gear for your mountain outings and rope handling. You can use it for belaying, but also to set up a triangle anchor or to set up an anchor around a rocky spur.

The BE SAFE SCREW carabiner is an HMS belay carabiner adapted for belaying. As such, it can accommodate two ropes at once, without the risk of them overlapping in the event of a fall. The reception cradle ensures that the two ropes slide together and does not generate friction on the sides of the carabiner when the rope is braked. This is true whether...